Modular Optics Compatibility - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

Modular Optics Compatibility

Table 1-6 SIP and SPA Compatibility Table for CEoP SPAs
SPA
24-Port Channelized T1/E1 ATM
CEoP SPA
2-Port Channelized T3/E3 ATM CEoP
SPA
E3 support is not available on the 2-Port Channelized T3/E3 ATM CEoP SPA on SIP-400 of the Cisco
Note
Series Router 7600
Modular Optics Compatibility
Some SPAs implement small form-factor pluggable (SFP) optical transceivers to provide network
connectivity. An SFP module is a transceiver device that mounts into the front panel to provide network
connectivity.
Cisco Systems qualifies the SFP modules that can be used with SPAs.
The SPAs will only accept the SFP modules listed as supported in this document. An SFP check is run
Note
every time an SFP module is inserted into a SPA and only SFP modules that pass this check will be usable.
Table 1-7
Table 1-7
SPA
1-Port, 2-Port, 3-Port and 4-Port OC-3c/STM-1
ATM SPA - v2
1-Port OC-12c/STM-4 ATM SPA
1-Port OC-48c/STM-16 ATM SPA
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
1-6
Product ID
SPA-24CHT1-CE-ATM
SPA-2CHT3-CE-ATM
shows the types of optics modules that have been qualified for use with a SPA:
SPA Optics Compatibility
Chapter 1
SIP Type
No Yes
No Yes
Qualified Optics Modules (Cisco Part Numbers)
SFP-OC3-MM
•
SFP-OC3-SR
•
SFP-OC3-IR1
•
SFP-OC3-LR1
•
SFP-OC3-LR2
•
ONS-SC-155-EL
•
SFP-OC12-MM
•
SFP-OC12-SR
•
SFP-OC12-IR1
•
SFP-OC12-LR1
•
SFP-OC12-LR2
•
SFP-OC48-IR1
•
• SFP-OC48-SR
SFP-OC48-LR2
•
SIP and SPA Product Overview
No No
No No
OL-5052-14