Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual page 126

2-Port Channelized T3/E3 ATM CEoP SPA Overview
1
TX (Transmit) connector
2 RX (Receive) connector
3
C/A (Carrier/Alarm) LED
The 2-Port Channelized T3/E3 ATM CEoP SPA LEDs are described in the following table.
Table 3-47
LED Label
C/A
A/L
STATUS
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
3-80
2-Port Channelized T3/E3 ATM CEoP SPA LEDs
Color State
Off Off
Green On
Amber On
Off Off
Green On
Amber On
Off Off
Amber On
Green On
Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
4
A/L (Active/Loopback)
5 STATUS LED
Meaning
Port is not enabled by software.
Port is enabled by software.
Port is enabled by software, and there is at least one alarm.
Port is not enabled by software.
Port is enabled by software, loopback is off.
Port is enabled by software, loopback is on.
SPA power is off.
SPA power is on and good, and SPA is being configured.
SPA is ready and operational.
OL-5052-14