Oc-192 Module Connections - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

1-Port OC-192c/STM-64 POS/RPR XFP SPA Overview
Figure 3-36
OC-192c/STM-64 POS/RPR XFP SPA.
Figure 3-36
RX TX
Note The 40-pin connector on the 1-Port OC-192c/STM-64 POS/RPR XFP SPA is used for resilient packet
ring (RPR) connections. This feature is not supported in.

OC-192 Module Connections

Table 3-21
SPA.
Table 3-21 OC-192 Specifications
Specification
Wavelength
Cabling distance (maximum)
Operating case temperature range
Tx Power
Receiver Sensitivity (maximum)
RX Overload
Maximum Receiver Power Damage
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
3-44
shows the cable type for use with the XFP optical transceiver module on the 1-Port
LC-Type Cable for the XFP Optical Transceiver Modules
/ /
shows the OC-192 specifications for use with the 1-Port OC-192c/STM-64 POS/RPR XFP
Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
/ /
/ /
Description
OC-192 SR-1: 1290 nm to 1330 nm
OC-192 IR-2: 1530 nm to 1565 nm
OC-192 LR-2: 1530 nm to 1565 nm
OC-192 SR-1: 2 km (1.2 miles)
OC-192 IR-2: 40 km (24.8 miles)
OC-192 LR-2: 50 miles (80 km)
OC-192 SR-1: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 IR-2: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 LR-2: 23 to 158 degrees F (–5 to 70 degrees C)
OC-192 SR-1: –6 dBm –1 dBm
OC-192 IR-2: –1 dBm +2 dBm
OC-192 LR-2: 0 to +4 dBm
OC-192 SR-1: –11 dBm
OC-192 IR-2: –14 dBm
OC-192 LR-2: –24 dBm
OC-192 SR-1: –1 dBm
OC-192 IR-2: +2 dBm
OC-192 LR-2: –7.0 dBm
OC-192 SR-1: +5 dBm
OC-192 IR-2: +5 dBm
OC-192 LR-2: +5 dBm
OL-5052-14