Preparing To Install A Sip Or A Shared Port Adapter; Required Tools And Equipment; Safety Guidelines - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

Preparing to Install a SIP or a Shared Port
Adapter
This chapter describes the general equipment, safety, and site preparation requirements for installing
SIPs and SPAs. This chapter contains the following sections:
•
•
•

Required Tools and Equipment

You need the following tools and parts to install SIPs and SPAs. If you need additional equipment,
contact a service representative for ordering information.
•
•
•
•
•
•
•
•
•

Safety Guidelines

This section provides safety guidelines that you should follow when working with any equipment that
connects to electrical power or telephone wiring.
OL-5052-14
Required Tools and Equipment, page 4-1
Safety Guidelines, page 4-1
Laser/LED Safety, page 4-8
Shared port adapter interface processor (SIP)
Shared port adapter (SPA)
SPA Services Card (SSC)
Number 1 Phillips and a 3/16-inch flat-blade screwdriver
Number 2 Phillips screwdriver
Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap supplied with the SIP or SPA
Antistatic mat
Antistatic container
Torque screwdriver with range from 8 to 12 inch-pounds (90 to 135 Newton-centimeters)
C H A P T E R
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
4
4-1