Installing And Removing A Sip; Handling Sips - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

Installing and Removing a SIP

This chapter describes how to install or remove SIPs on the Cisco 7600 series routers. This chapter
contains the following sections:
•
•
•

Handling SIPs

Each SIP circuit board is mounted to a metal carrier and is sensitive to electrostatic discharge (ESD)
damage. Before you begin installation, read
Adapter,"
Caution Always handle the SIP by the carrier edges and handle; never touch the SIP components or connector
pins. (See
When a slot is not in use, a blank filler plate must be installed in the empty slot to allow the router or
switch to conform to electromagnetic interference (EMI) emissions requirements and to allow proper
airflow across the installed modules. If you plan to install a SIP in a slot that is not in use, you must first
remove the blank filler plate.
OL-5052-14
Handling SIPs, page 5-1
Online Insertion and Removal, page 5-2
SIP Installation and Removal, page 5-8
for a list of parts and tools required for installation.
Figure 5-1.)
C H A P T E R
Chapter 4, "Preparing to Install a SIP or a Shared Port
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
5
5-1