Using Show Commands To Display Spa Information; Spa Blank Filler Plates - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

SPA Blank Filler Plates

Using show Commands to Display SPA Information

Table 6-1
Table 6-1
Command
show running-config
show hw-module subslot all oir
show diag
show hw-module subslot all fpd
show version
SPA Blank Filler Plates
SPA blank filler plates are available to fill an unused SPA subslot.
When a SPA subslot is not in use, a SPA blank filler plate must be installed in the empty subslot to allow
the router or switch to conform to electromagnetic interference (EMI) emissions requirements and to
allow proper airflow across the SPAs. If you plan to install a new SPA in a subslot that is not in use, you
must first remove the SPA blank filler plate.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
6-6
describes the show commands you can use to display SPA information.
show Commands to Display SPA Information
Chapter 6
Type of Information Provided
The router's running configuration and interfaces available in
the system.
The operational status of all SPAs in the system.
SPA type in that slot, number of ports, hardware revision,
part number, and EEPROM contents.
FPD version information of SPAs in the system.
Cisco IOS software version, names and sources of
configuration files, and boot images.
Installing and Removing a Shared Port Adapter
OL-5052-14