2-Port And 4-Port Oc-48C/Stm-16 Pos Spa; 2-Port And 4-Port Oc-48C/Stm-16 Pos Spa Leds - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

2-Port and 4-Port OC-48c/STM-16 POS SPA

Figure 3-28
RX TX
The 40-pin connector on the 1-Port OC-48c/STM-16 POS SPA is used for resilient packet ring (RPR)
Note
connections.
2-Port and 4-Port OC-48c/STM-16 POS SPA
The following sections describe the 2-Port and 4-Port OC-48c/STM-16 POS SPA:
•
•
•

2-Port and 4-Port OC-48c/STM-16 POS SPA LEDs

The 2-Port and 4-Port OC-48c/STM-16 POS SPA has five types of LEDs: four LEDs for each port on
the SPA and one STATUS LED, as shown in
Figure 3-29
1
2
3
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
3-34
LC-Type Cable for the SFP Optical Transceiver Modules
/ /
1-Port OC-48c/STM-16 ATM SPA LEDs, page 3-30
1-Port OC-48c/STM-16 ATM SPA Interface Specifications, page 3-31
1-Port OC-48c/STM-16 ATM SPA Cables and Connectors, page 3-31
2-Port OC-48c/STM-16 POS SPA Faceplate
1 2
3 4
PTH (Pass Through) LED
PRT (Protect) LED
CAR (Carrier Alarm) LED
Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
/ /
/ /
Figure 3-29.
4 ACT (Active Loopback) LED
5 STATUS LED
SPA-2XOC48-POS/RPR
5
OL-5052-14