1-Port Oc-192C/Stm-64 Pos/Rpr Vsr Optics Spa Interface Specifications - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
Table 3-22 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA LEDs (continued)
LED Label
PASSTHRU
MATESYNC
CARRIER
ACTIVE
STATUS

1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Interface Specifications

The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA contains a SONET/SDH framer to process
incoming and outgoing SONET or SDH frames. The framer operates at OC-192/STM-64 line rates (9.95
Gbps).
Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP])
and is mapped into the STS-192c/STM-64 frame.
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA interface is compliant with the following
RFCs:
•
•
For information on SNMP MIB support, see "Implementing SNMP on Cisco IOS XR Software" in
Cisco IOS XR System Management Configuration Guide.
1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Fixed Optical Transceiver,
Connector, and Cables
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA uses fixed optical transceivers, one for receive
(RX) and one for transmit (TX), for SONET and SDH connection to the network. Only Very Short Reach
(VSR) optics are supported.
The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA uses multimode MTP-type connectors:
•
OL-5052-14
Color
Off
Amber
Off
Green
Off
Green
Amber
Off
Green
Amber
Off
Green
Amber
RFC 1662, PPP in HDLC-like Framing
RFC 2615, PPP over SONET/SDH
Multimode—9.95 Gbps, OC-192 optical fiber (SONET STS-192c or SDH STM-64c)
1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Overview
State Meaning
Off Port is not in pass-through mode.
On Port is in pass-through mode.
Off Mate port is not synchronized.
On Mate port is synchronized.
Off Port is not enabled by software.
On Port is enabled by software, and there is a valid SONET signal
without alarms.
On Port is enabled by software, and there is at least one alarm
(LOS, LOF, RDI, and so on).
Blinking SRP mode mismatch alarm is indicated.
Off Port is not enabled by software.
On Port is enabled by software, and loopback is off.
On Port is enabled by software, and loopback is on.
Off SPA power off.
On SPA is ready and operational.
On SPA power is on and good, and the SPA is being configured.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
3-47