1-Port Oc-192C/Stm-64 Pos/Rpr Spa Overview; 1-Port Oc-192C/Stm-64 Pos/Rpr Spa Leds; Port Oc-192C/Stm-64 Pos/Rpr Spa Fixed Optical Transceiver, 40-Pin Connector, And Cables - Cisco 7600 SIP 200 - SPA Interface Processor 200 Hardware Installation Manual

1-Port OC-192c/STM-64 POS/RPR SPA Overview

1-Port OC-192c/STM-64 POS/RPR SPA Overview
The 1-Port OC-192c/STM-64 POS/RPR SPA is a double-height SPA that is installed in two SIP subslots.
The 1-Port OC-192c/STM-64 POS/RPR SPA provides SONET and SDH network connectivity with a
bandwidth of 9.95 Gbps.
For more information about SPA bandwidth, see the "Bandwidth Oversubscription" section on page 2-2.
For more information about SPAs and their compatibility with SIPs and modular optics, see the "SIP and
SPA Compatibility" chapter in this guide.
The 1-Port OC-192c/STM-64 POS/RPR SPA uses a single,10-Gbps fixed optical receptacle allowing a
connection to single-mode optical fiber. For more information on the optical fiber cables used with this
SPA, see the
page
The following sections describe the 1-Port OC-192c/STM-64 POS/RPR SPA:
•
•
•

1-Port OC-192c/STM-64 POS/RPR SPA LEDs

The 1-Port OC-192c/STM-64 POS/RPR SPA has six LEDs, as shown in
Figure 3-32 1-Port OC-192c/STM-64 POS/RPR SPA Faceplate
1
2
3
The WRAP, PASSTHRU, and MATESYNC LEDs apply to the SPA in RPR/SRP mode only. In
Note
Cisco IOS Release 12.0(31)S, RPR/SRP mode is not supported.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
3-38
"OC-3c/STM-1 POS SPA SFP Optical Transceiver Modules and Cables" section on
3-22.
1-Port OC-192c/STM-64 POS/RPR SPA LEDs, page 3-38
1-Port OC-192c/STM-64 POS/RPR SPA Interface Specifications, page 3-39

1-Port OC-192c/STM-64 POS/RPR SPA Fixed Optical Transceiver, 40-Pin Connector, and Cables,

page 3-40
TX
WRAP LED
PASSTHRU LED
MATESYNC LED
Chapter 3
1 3 5
2 4
RX
4
5
6
Overview: Cisco 7600 Series Router Shared Port Adapters
Figure 3-32.
CARRIER LED
ACTIVE LED
STATUS LED
6
SPA-OC192POS LR
OL-5052-14