Dhcp Commands; Dhcp Client - Accton Technology VS4512DC Management Manual

Command Line Interface

DHCP Commands

These commands are used to configure Dynamic Host Configuration Protocol
(DHCP) client. You can configure any VLAN interface to be automatically assigned
an IP address via DHCP.

DHCP Client

Command
ip dhcp client-identifier
ip dhcp restart client
ip dhcp client-identifier
This command specifies the DCHP client identifier for the current interface. Use the
no form to remove this identifier.
Syntax
ip dhcp client-identifier {text text | hex hex}
no ip dhcp client-identifier
• text - A text string. (Range: 1-15 characters)
• hex - The hexadecimal value.
Default Setting
None
Command Mode
Interface Configuration (VLAN)
Command Usage
This command is used to include a client identifier in all communications with
the DHCP server. The identifier type depends on the requirements of your
DHCP server.
Example
Console(config)#interface vlan 2
Console(config-if)#ip dhcp client-identifier hex 00-00-e8-66-65-72
Console(config-if)#
Related Commands
ip dhcp restart client (4-83)
4-82
Specifies the DHCP client identifier for this switch
Submits a BOOTP or DHCP client request
Function Mod Pag
e e
IC 4-82
PE 4-83