Table of Contents
Advertisement
Configuring the Switch
CLI – This example shows the connection status for Port 5.
Console#show interfaces status ethernet 1/5
Information of Eth 1/5
Basic information:
Port type: 1000T
Mac address: 00-30-f1-47-58-46
Configuration:
Name:
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full, 1000full,
Broadcast storm: Enabled
Broadcast storm limit: 500 packets/second
Flow control: Disabled
Lacp: Disabled
Port security: Disabled
Max MAC count: 0
Port security action: None
Combo forced mode: None
Current status:
Link status: Down
Port operation status: Up
Operation speed-duplex: 100full
Flow control type: None
Console#
Configuring Interface Connections
You can use the Port Configuration or Trunk Configuration page to enable/disable an
interface, set auto-negotiation and the interface capabilities to advertise, or manually
fix the speed, duplex mode, and flow control.
Command Attributes
•
– Allows you to label an interface. (Range: 1-64 characters)
Name
•
– Allows you to manually disable an interface. You can disable an
Admin
interface due to abnormal behavior (e.g., excessive collisions), and then
reenable it after the problem has been resolved. You may also disable an
interface for security reasons.
•
Speed/Duplex
•
Flow Control
3-42
– Allows you to manually set the port speed and duplex mode.
– Allows automatic or manual selection of flow control.
4-91
Advertisement
Table of Contents
