Show Ip Redirects; Ping - Accton Technology VS4512DC Management Manual

show ip redirects

This command shows the default gateway configured for this device.
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show ip redirects
ip default gateway 10.1.0.254
Console#
Related Commands
ip default-gateway (4-168)

ping

This command sends ICMP echo request packets to another node on the network.
Syntax
ping host [count count][size size]
• host - IP address or IP alias of the host.
• count - Number of packets to send. (Range: 1-16, default: 5)
• size - Number of bytes in a packet. (Range: 32-512, default: 32)
The actual packet size will be eight bytes larger than the size specified
because the switch adds header information.
Default Setting
This command has no default for the host.
Command Mode
Normal Exec, Privileged Exec
Command Usage
• Use the ping command to see if another site on the network can be reached.
• Following are some results of the ping command:
• Normal response - The normal response occurs in one to ten seconds,
depending on network traffic.
• Destination does not respond - If the host does not respond, a "timeout" appears
in ten seconds.
• Destination unreachable - The gateway for this destination indicates that the
destination is unreachable.
• Network or host unreachable - The gateway found no corresponding entry in the
route table.
• Press <Esc> to stop pinging.
IP Interface Commands
4-169