Displaying Interface Settings - Accton Technology VS4512DC Management Manual

Web – Click Spanning Tree, STA, Configuration. Modify the required attributes, and
click Apply.
CLI – This example enables Spanning Tree Protocol, and then configures the STA
parameters.
Console(config)#spanning-tree
Console(config)#spanning-tree priority 40000
Console(config)#spanning-tree hello-time 5
Console(config)#spanning-tree forward-time 20
Console(config)#spanning-tree max-age 38
Console(config)#spanning-tree pathcost method long
Console(config)#spanning-tree transmission-limit 4

Displaying Interface Settings

The STA Port Information and STA Trunk Information pages display the current
status of ports and trunks in the Spanning Tree.
Command Attributes
• Spanning Tree – Shows if STA has been enabled on this interface.
• STA Status – Displays current state of this port within the Spanning Tree:
- Discarding - Port receives STA configuration messages but does not forward
packets.
- Learning - Port has transmitted configuration messages for an interval set by
the Forward Delay parameter without receiving contradictory information. Port
address table is cleared, and the port begins learning addresses.
- Forwarding - Port forwards packets, and continues learning addresses.
Spanning Tree Algorithm Configuration
4-126
4-129
4-128
4-127
4-128
4-130
4-130
3-81