System Defaults
The switch's system defaults are provided in the configuration file
"Factory_Default_Config.cfg." To reset the switch defaults, this file should be set as
the startup configuration file (page 3-17).
The following table lists some of the basic system defaults.
Function
IP Settings
Console Port
Connection
Authentication
Parameter
Management VLAN
DHCP
BOOTP
User Specified
IP Address
Subnet Mask
Default Gateway
Baud Rate
Data bits
Stop bits
Parity
Local Console Timeout
Privileged Exec Level
Normal Exec Level
Enable Privileged Exec from
Normal Exec Level
RADIUS Authentication
TACACS Authentication
802.1x Port Authentication
SSL
HTTPS
SSH version 2.0
Port Security
Default
1
Enabled
Disabled
Disabled
0.0.0.0
255.0.0.0
0.0.0.0
9600
8
1
none
0 (disabled)
Username "admin"
Password "admin"
Username "guest"
Password "guest"
Password "super"
Disabled
Disabled
Disabled
Enabled
Enabled
Enabled
Disabled
System Defaults
1-5