Multicast Filtering Commands; Igmp Snooping Commands; Ip Igmp Snooping - Accton Technology VS4512DC Management Manual

Command Line Interface
Example
The following shows that HTTP traffic has been mapped to CoS value 0:
Console#show map ip port
TCP port mapping status: disabled
Port Port no. COS
--------- -------- ---
Eth 1/ 5
Console#
Related Commands
map ip port (Interface Configuration) (4-155)

Multicast Filtering Commands

This switch uses IGMP (Internet Group Management Protocol) to query for any
attached hosts that want to receive a specific multicast service. It identifies the ports
containing hosts requesting a service and sends data out to those ports only. It then
propagates the service request up to any neighboring multicast switch/router to
ensure that it will continue to receive the multicast service.
Command Groups
IGMP Snooping
IGMP Query
Static Multicast Routing

IGMP Snooping Commands

Command

ip igmp snooping

ip igmp snooping vlan static Adds an interface as a member of a multicast group
ip igmp snooping version
show ip igmp snooping
show mac-address-table
multicast
ip igmp snooping
This command enables IGMP snooping on this switch. Use the no form to disable it.
Syntax
[no] ip igmp snooping
4-158
80 0
Configures multicast groups via IGMP snooping or static assignment,
sets the IGMP version, displays current snooping and query settings,
and displays the multicast service and group members
Configures IGMP query parameters for multicast filtering at Layer 2
Configures static multicast router ports
Enables IGMP snooping
Configures the IGMP version for snooping
Shows the IGMP snooping and query configuration
Shows the IGMP snooping MAC multicast list
Function
Function
Pag
e
4-158
4-161
4-165
Mode Pag
e
GC 4-158
GC 4-159
GC 4-159
PE 4-160
PE 4-161