Queue Mode - Accton Technology VS4512DC Management Manual

Command Line Interface
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The precedence for priority mapping is IP Port, IP Precedence or IP DSCP, and
default switchport priority.
• The default priority applies for an untagged frame received on a port set to
accept all frame types (i.e, receives both untagged and tagged frames). This
priority does not apply to IEEE 802.1Q VLAN tagged frames. If the incoming
frame is an IEEE 802.1Q VLAN tagged frame, the IEEE 802.1p User Priority bits
will be used.
• This switch provides four priority queues for each port. It is configured to use
Weighted Round Robin, which can be viewed with the show queue bandwidth
command. Inbound frames that do not have VLAN tags are tagged with the
input port's default ingress user priority, and then placed in the appropriate
priority queue at the output port. The default priority for all ingress ports is zero.
Therefore, any inbound frames that do not have priority tags will be placed in
queue 0 of the output port. (Note that if the output port is an untagged member
of the associated VLAN, these frames are stripped of all VLAN tags prior to
transmission.)
Example
The following example shows how to set a default priority on port 3 to 5:
Console(config)#interface ethernet 1/3
Console(config-if)#interface ethernet 1/3

queue mode

This command sets the queue mode to strict priority or Weighted Round-Robin
(WRR) for the class of service (CoS) priority queues. Use the no form to restore the
default value.
Syntax
queue mode {strict | wrr}
no queue mode
• strict - Services the egress queues in sequential order, transmitting all
traffic in the higher priority queues before servicing lower priority queues.
• wrr - Weighted Round-Robin shares bandwidth at the egress ports by using
scheduling weights 1, 3, 5, 7 for queues 0 - 3 respectively.
Default Setting
Weighted Round Robin
Command Mode
Global Configuration
4-148