Table of Contents
Advertisement
2. A suffix of "A" in the profile name (e.g., S2-16-16A) indicates that this
profile is for both VDSL and ADSL lines in a bundle. Profiles without a
suffix of "A" in the profile name (e.g., S1-16-16) are for VDSL lines only.
3. The following profiles are recommended for use with this switch: S1-16-16,
S2-16-16A, A1-34-11, and- A2-34-11A.
4. The maximum distances for VDSL links using the recommended profiles
are:
Upstream
16 Mbps
11 Mbps
5. Type-1 26 AWG (100 ohm)/0.4 mm, or Type-2 24 AWG (100 ohm)/0.5 mm
cable may be installed to achieve the maximum distance. However,
typically, 24 AWG (100 ohm)/0.5 mm wire is better than 26 AWG (100
ohm)/0.4 mm wire. Note that the distance may be limited by factors such
as how the cable is bundled, and the interference and noise on the link.
6. Public profiles conform to specific standards such as ANSI or ETSI.
Private profiles do not conform to these standards.
Example
Console#config
Console(config)#efm profile global S1-16-16
Console(config)#
Related Commands
efm profile (4-103)
efm profile
Use this command to assign profiles for speed to a specific VDSL port on the switch.
Syntax
efm profile profile name
profile name - Name of the profile.
Default Setting
None
Command Mode
Interface Configuration
Command Usage
Assigns a profile to a specific VDSL port. For details of the these profiles see
efm profile global on page 4-102.
Downstream
16 Mbps
Symmetric
34 Mbps
Asymetric
VDSL Commands
Mode
Max. Range
600m (1970 ft)
610m (2000 ft)
4-103
Advertisement
Table of Contents
