Command Line Interface
Example
Console#show controllers efm line-table
VDSL_LINE_ENTRY :
Ethernet 1/1
Ethernet 1/1
Ethernet 1/1
Ethernet 1/1
. .
.
VDSL_LINE_ENTRY :
Ethernet 1/12
Ethernet 1/12
Ethernet 1/12
Ethernet 1/12
Console#
Parameter
Line Coding
Line Type
Config Profile
Alarm Config Profile
show controllers efm phy-table
This command displays physical interface information for the selected VDSL port.
For details see "Displaying VDSL Interface Information" on page 3-66.
Syntax
show controllers efm phy-table {vtu-r | vtu-c} [interface]
•
vtu-r – VTU (VDSL Transceiver Unit) at the remote end of the line
•
vtu-c – VTU (VDSL Transceiver Unit) at the near (central) end of the line
•
interface – Ethernet interface to display
• unit/port
- unit - This is device 1
- port - Port number
4-118
Line Coding
Line Type
Line Config Profile
Line Alarm Config Profile
Line Coding
Line Type
Line Config Profile
Line Alarm Config Profile
Specifies the VDSL coding type used on this line.
1. Others (none of the following)
2. Multiple Carrier Modulation
3. Single Carrier Modulation
Defines the type of VDSL physical line by defining whether and how the line is
channelized.
1. No channels exist
2. Only fast channels exist
3. Only interleaved channels exists
4. Either fast or interleaved channels exist
5. Both fast and interleaved channels exist
In this version, only "DEFVAL" is displayed.
The alarm profile is pre-configured to send trap messages via SNMP protocol
to register errors on the VDSL line.
3
4
DEFVAL
DEFVAL
3
4
DEFVAL
DEFVAL
Description