Mapping Ip Precedence - Accton Technology VS4512DC Management Manual

Configuring the Switch
CLI – The following example enables IP Precedence service on the switch.
Console(config)#map ip precedence
Console(config)#

Mapping IP Precedence

The Type of Service (ToS) octet in the IPv4 header includes three precedence bits
defining eight different priority levels ranging from highest priority for network control
packets to lowest priority for routine traffic. The default IP Precedence values are
mapped one-to-one to Class of Service values (i.e., Precedence value 0 maps to
CoS value 0, and so forth). Bits 6 and 7 are used for network control, and the other
bits for various application types. ToS bits are defined in the following table.
Priority Traffic Type
Level
7 Network Control
6 Internetwork Control
5 Critical
4 Flash Override
Command Attributes
•
IP Precedence Priority Table –
•
Class of Service Value –
value. Note that "0" represents low priority and "7" represent high priority.
Web – Click Priority, IP Precedence Priority. Select an entry from the IP Precedence
Priority Table, enter a value in the Class of Service Value field, and then click Apply.
3-104
Priority
Level
3
2
1
0
Shows the IP Precedence to CoS map.
Maps a CoS value to the selected IP Precedence
Traffic Type
Flash
Immediate
Priority
Routine
4-152