Configuring the Switch
CLI – The following example shows IP Port 80 mapped to CoS value 0 for ethernet
port 1.
Console(config)#map ip port
Console(config)#interface ethernet 1/5
Console(config-if)#map ip port 80 cos 0
Console(config-if)#end
Console# show map ip port ethernet 1/5
TCP port mapping status: enabled
Port
Port no. COS
--------- -------- ---
Eth 1/ 5
Eth 1/ 5
Eth 1/ 5
1020
Console#
Copy Priority Settings
In the Copy Settings page you can copy the priority settings from a selected port or
trunk to another selected port or trunk.
Command Attributes
• Source Interface – The port or trunk from which the priority settings are copied.
• Destination Interface – The port or trunk to which the priority settings are
copied.
Web – Click Priority, Copy Settings. Check the type of priority settings to be copied,
select the source interface and destination interface, then click Copy Settings.
3-108
23
0
80
0
6
4-155
4-155
4-157