Accton Technology VS4512DC Management Manual page 136

Configuring the Switch
Web – Click Priority, IP DSCP Priority. Select an entry from the DSCP table, enter a
value in the Class of Service Value field, then click Apply.
CLI – The following example globally enables DSCP Priority service on the switch,
maps DSCP value 0 to CoS value 1 (on port 1), and then displays the DSCP Priority
settings.
Console(config)#map ip dscp
Console(config)#interface ethernet 1/1
Console(config-if)#map ip dscp 1 cos 0
Console(config-if)#end
Console#show map ip dscp ethernet 1/1
DSCP mapping status: enabled
Port DSCP COS
--------- ---- ---
Eth 1/ 1 0
Eth 1/ 1 1
Eth 1/ 1 2
Eth 1/ 1 3
. .
.
Eth 1/ 1 61
Eth 1/ 1 62
Eth 1/ 1 63
Console#
* Mapping specific values for IP DSCP is implemented as an interface configuration command,
but any changes will apply to the all interfaces on the switch.
3-106
0
0
0
0
0
0
0
4-153
4-84
4-154
4-156