Configuring Global Settings - Accton Technology VS4512DC Management Manual

Vdsl switch (with ac power connector) supporting 12 vdsl lines, with 2 slots for optional 1000base-sx, 1000base-lx, 1000base-t or 1000base-x gbic uplink modules
Table of Contents

Advertisement

CLI – This command displays global STA settings, followed by settings for each port.
Console#show spanning-tree
Spanning-tree information
---------------------------------------------------------------
Spanning tree mode
Spanning tree enable/disable
Priority
Bridge Hello Time (sec.)
Bridge Max Age (sec.)
Bridge Forward Delay (sec.)
Root Hello Time (sec.)
Root Max Age (sec.)
Root Forward Delay (sec.)
Designated Root
Current root port
Current root cost
Number of topology changes
Last topology changes time (sec.):23771
Transmission limit
Path Cost Method
.
.
.
Note: The current root port and current root cost display as zero when this device is not
connected to the network.

Configuring Global Settings

Global settings apply to the entire switch.
Command Usage
• Spanning Tree Protocol
Uses RSTP for the internal state machine, but sends only 802.1D BPDUs.
Rapid Spanning Tree Protocol
• RSTP supports connections to either STP or RSTP nodes by monitoring the
incoming protocol messages and dynamically adjusting the type of protocol
messages the RSTP node transmits, as described below:
- STP Mode – If the switch receives an 802.1D BPDU (i.e., STP BPDU) after a
port's migration delay timer expires, the switch assumes it is connected to an
802.1D bridge and starts using only 802.1D BPDUs.
- RSTP Mode – If RSTP is using 802.1D BPDUs on a port and receives an
RSTP BPDU after the migration delay expires, RSTP restarts the migration
delay timer and begins using RSTP BPDUs on that port.
Command Attributes
Basic Configuration of Global Settings
• Spanning Tree State – Enables/disables STA on this switch. (Default:
Enabled)
• Spanning Tree Type – Specifies the type of spanning tree used on this switch:
- STP: Spanning Tree Protocol (IEEE 802.1D); i.e., when this option is
selected, the switch will use RSTP set to STP forced compatibility mode).
- RSTP: Rapid Spanning Tree (IEEE 802.1w); RSTP is the default.
Spanning Tree Algorithm Configuration
:RSTP
:enable
:32768
:2
:20
:15
:2
:20
:15
:32768.000087654321
:1
:200000
:1
:3
:long
4-135
3-79

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vs4512Vdsl switch-vs4512Vdsl switch-vs4512dc

Table of Contents