Smtp Alert Commands - Accton Technology VS4512DC Management Manual

Command Line Interface
The following example displays settings for the trap function.
Console#show logging trap
Syslog logging: Enable
REMOTELOG status: disable
REMOTELOG facility type: local use 7
REMOTELOG level type: Debugging messages
REMOTELOG server IP address: 1.2.3.4
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
Console#
Field
Syslog logging
REMOTELOG status
REMOTELOG
facility type
REMOTELOG level type The severity threshold for syslog messages sent to a remote server as specified in
REMOTELOG
server IP address
Related Commands
show logging sendmail (4-43)

SMTP Alert Commands

Configures SMTP event handling, and forwarding of alert messages to the specified
SMTP servers and email recipients.
Command
logging sendmail host
logging sendmail level
logging sendmail
source-email
logging sendmail
destination-email
logging sendmail
show logging sendmail
4-40
Shows if system logging has been enabled via the logging on command.
Shows if remote logging has been enabled via the logging trap command.
The facility type for remote logging of syslog messages as specified in the logging
facility command.
the logging trap command.
The address of syslog servers as specified in the logging host command.
SMTP servers to receive alert messages
Severity threshold used to trigger alert messages
Email address used for "From" field of alert messages
Email recipients of alert messages
Enables SMTP event handling
Displays SMTP event handler settings
Description
Function Mode Page
GC 4-41
GC 4-41
GC 4-42
GC 4-42
GC 4-43
NE, PE 4-43