Logon Screen - Intel 470F - NetStructure Switch User Manual

C H A P T E
46
470T Ch5 - Sec 1-Nav & Config.p65
R 5 Intel® NetStructure™ 470T and 470F Switches User Guide
Using Telnet
1 Open a Telnet application. In Windows 98 or Windows NT*, select
Run from the Start Menu and then type: telnet and press E.
2 From the Terminal menu, select Preferences. Make sure the emulation
type is VT-100/ANSI and that VT100 arrows are enabled.
3 From the Connect menu, select Remote System. Enter the IP address of
the switch and click Connect.
4 Log on to Local Management. By default, no password or username is
assigned. To assign them, see the section titled User Accounts in this
chapter.

Logon Screen

Description
By default, no username or password is assigned to the switch. Press
E twice to log on to the Local Manager. Usernames and passwords
can consist of any characters and can be up to fifteen characters in length.
Remember that usernames and passwords are also case-sensitive.
46 4/12/00, 10:20 AM