Displaying Hardware Layer 3 Switching Statistics - Cisco 6500 Series Software Configuration Manual

Displaying Hardware Layer 3 Switching Statistics

Displaying Hardware Layer 3 Switching Statistics
Hardware Layer 3 switching statistics are obtained on a per-VLAN basis.
To display hardware Layer 3 switching statistics, perform this task:
Command
Router# show interfaces {{type
{port-channel number}}
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to display hardware Layer 3 switching statistics:
Router# show interfaces gigabitethernet 9/5 | include Switched
L2 Switched: ucast: 8199 pkt, 1362060 bytes - mcast: 6980 pkt, 371952 bytes
L3 in Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes mcast
L3 out Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
To display adjacency table information, perform this task:
Command
Router# show adjacency [{{type
{port-channel number}} | detail | internal | summary]
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to display adjacency statistics:
Router# show adjacency gigabitethernet 9/5 detail
Protocol Interface
IP
Adjacency statistics are updated approximately every 60 seconds.
Note
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
17-6
1
slot/port} |
1
slot/port} |
GigabitEthernet9/5
Chapter 17 Configuring IP Unicast Layer 3 Switching on Supervisor Engine 2
Purpose
Displays hardware Layer 3 switching statistics.
Purpose
Displays adjacency table information. The optional detail
keyword displays detailed adjacency information, including
Layer 2 information.
Address
172.20.53.206(11)
504 packets, 6110 bytes
00605C865B82
000164F83FA50800
ARP 03:49:31
78-14099-04