Configuring Circuit Emulation Service Over Packet-Switched Network (Cesopsn) - Cisco ASR 900 Series Configuration Manual

Configuring Pseudowire
Configuring Circuit Emulation Service over Packet-Switched
Network (CESoPSN)
SUMMARY STEPS
1. enable
2. configure terminal
3. controller [e1 | t1] slot/subslot
4. cem-group group-number timselots timeslots
5. exit
6. interface cem slot/subslot
7. xconnect ip_address encapsulation mpls
8. exit
9. exit
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3 controller [e1 | t1] slot/subslot
Example:
Router(config)# controller e1 0/0
Example:
Step 4 cem-group group-number timselots timeslots
Example:
Router(config-controller)# cem-group 5
timeslots 1-24

Configuring Circuit Emulation Service over Packet-Switched Network (CESoPSN)

Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Enters configuration mode for the E1 or T1 controller.
Assigns channels on the T1 or E1 circuit to the circuit
emulation (CEM) channel. This example uses the timeslots
parameter to assign specific timeslots to the CEM channel.
23