Connecting To The Scsi Ports; System Scsi Port Connection - HP Visualize J5000 - Workstation Owner's Manual
Hp visualize j5000, j7000 workstations owner's guide (a4978-90013)
Hide thumbs
Also See for Visualize J5000 - Workstation:
- Supplementary manual (214 pages) ,
- Owner's manual (208 pages) ,
- Handbook (178 pages)
Table of Contents
Advertisement
Connecting to the SCSI Ports
This section describes how to connect to the system SCSI ports (Ultra
Narrow Single-Ended and Ultra2 Wide Low-Voltage Differential).
System SCSI Port Connection
The system contains two SCSI connectors:
• Ultra Narrow Single-Ended SCSI (NSE SCSI) connector
• Ultra2 Wide Low-Voltage Differential SCSI (LVD SCSI) connector
The illustration below shows the two SCSI connectors. SCSI cables
connect to these ports with a high-density thumbscrew connector.
It is necessary to put a terminator on unused SCSI connectors on the
NOTE
back panel, or the last device connected to the SCSI bus. Terminators are
shipped with the system. Be sure to use a NSE SCSI terminator for the
NSE SCSI bus and an LVD terminator for the LVD SCSI bus.
Chapter 7
Ultra Narrow Single-Ended
SCSI Connector
Ultra2 Wide
Low-Voltage Differential
SCSI Connector
SCSI Connections
Connecting to the SCSI Ports
135
Advertisement
Table of Contents
Need help?
Do you have a question about the Visualize J5000 - Workstation and is the answer not in the manual?
Questions and answers