Displaying And Setting The Security Mode - HP Visualize J5000 - Workstation Owner's Manual

Displaying and Setting the Security Mode

The SECure flag is a variable stored in non-volatile memory.
(Non-volatile memory retains its contents even after power is turned off.)
If you reset this flag to a new value, the change takes effect the next time
you reboot the computer.
When the SECure flag is set to on, auto boot and auto search are enabled
and cannot be stopped. The system boots from the default boot paths
regardless of user intervention.
To display the current setting for the SECure flag, enter the following
command at the prompt and press
secure
To set the SECure flag on or off, type one of the following commands at
the prompt and press
secure on
secure off
Chapter 8
Displaying and Setting the Security Mode
:
Enter
:
Enter
The Boot Console Interface
163