Dds Drive Installation - HP Visualize J5000 - Workstation Owner's Manual

DDS Drive Installation

NOTE Before opening the system unit to install a DDS drive, determine the
SCSI IDs currently in use on your computer, so as to avoid SCSI ID
conflicts.
To install a DDS drive, follow the steps below:
1. Using standard static-suppression practices (described in the Preface
2. Remove the DDS/floppy drive bracket from the main chassis. The
Figure 2-18 Removing the DDS/Floppy Drive Bracket
3. Remove the filler panels from the DDS drive bracket and save them
Chapter 2
Changing Your Computer's Hardware Configuration
of this document), remove the computer's front panel, as described in
"Removing the Front Panel" on page 44, and top cover, as described
in "Opening the Top Cover" on page 46. Then remove the DDS-drive
bay's EMI (electromagnetic interference) cover—the thin metal cover
that is snapped in place above the DDS drive bay.
bracket is referred to as the "DDS/floppy drive bracket" because the
same bracket can house either a DDS drive or a floppy drive (but not
both simultaneously).
Filler Panels
for future use. Four of the six screws will be used to secure the DDS
drive to its bracket; save the remaining two for future use.
DDS Drive Installation
65