HP Visualize J5000 - Workstation Owner's Manual page 54

Changing Your Computer's Hardware Configuration
Installing Memory
4. Re-install the air guide with the four screws removed earlier (so it
again looks like Figure 2-7 on page 51), close the system unit and
reconnect all cables.
5. Verify that this installation was successful by following the steps in
"Displaying the Memory Configuration" on page 156.
If you have only replaced a faulty DIMM, you must execute the pdt
clear command in the service menu of the Boot Console Interface.
Answer yes (Y) to the prompt "Continue? (Y/N) >
54 Chapter 2