HP Visualize J5000 - Workstation Owner's Manual page 148

The Boot Console Interface
Displaying and Setting Paths
To display the current setting for a particular system path, follow the
directions in "Accessing the Boot Console Interface" on page 141, and
then type the following at the prompt and press
Main Menu: Enter command> path path_type
where path_type is one of the path types listed in Table 8-1.
For example, to get the path to the primary boot device, follow the
directions in "Accessing the Boot Console Interface" earlier in this
chapter, and then type the following at the prompt and press
Main Menu: Enter command> path primary
To set a system path to a new value, follow the directions in "Accessing
the Boot Console Interface" on page 141, and then type the following at
the prompt and press
Main Menu: Enter command> path path_type path
where path_type is one of the path types listed in Table 8-1 and path is
the specification of the path in Mnemonic Style Notation (as described in
the table above). For example, to set the primary boot path to a SCSI
disk with ID of 6.0, follow the directions in "Accessing the Boot Console
Interface" on page 141, and then type the following at the prompt and
press :
Enter
Main Menu: Enter command> path pri scsi.6.0
148
:
Enter
:
Enter
:
Enter
Chapter 8