HP Visualize J5000 - Workstation Owner's Manual page 78

Hot-Pluggable Hard Disk Drives
The Disk Drives
Figure 3-3 Installing a Hard Disk Drive into its Tray
Screw-storage tab
Release lever
4. Insert these four screws through the rubber grommets and into the
NOTE Do not remove the grommets; if they are removed, the drive would not be
held securely in the tray and may be damaged as a result.
Once the disk drive is installed into the drive tray, the assembly can be
inserted into the desired hard-drive slot.
78
drive in it, the four screws required to secure the drive to the tray are
stored in two tabs on the tray (see illustration below). Remove these
four screws from the storage tabs.
corresponding holes in the disk drive, and tighten them with a T15
Torx driver. There are four rubber grommets, although only two are
visible in the illustration above.
Grommets (do not remove)
Screw-storage tab
Release hook
Chapter 3