Power Cord Connectors - HP Visualize J5000 - Workstation Owner's Manual

drives
accompanies each SCSI device for specific information concerning its use.
Refer to the appendix "SCSI Connections" for information about
connecting SCSI devices to your computer.
WARNING Do not attach FWD SCSI devices to the LVD SCSI port, or
damage will occur.
NOTE When attaching external SCSI devices, be sure to terminate the last
device on each external SCSI bus. The terminators are included in a
small plastic bag that was shipped with your machine. Before powering
up your computer, make sure that the last external SCSI device in each
SCSI chain has a terminator.
If you have no external SCSI devices, install the terminators directory on
the connectors on the rear panel of the computer.

Power Cord Connectors

Plug the workstation's power cord into the power cord connector to
provide AC power to the system. Note that the HP V
J7000 have different types of power cords, because of their differing
power requirements:
Figure 1-6 Power Connectors
The power connector on the left is used on the J5000 (notice that it is a
keyed connector, requiring a 15-amp circuit), and the one on the right is
used on the J7000 because of its greater power demand (20 amps).
Chapter 1
and CD-ROM drives.
System Overview
System Unit Rear Panel Connectors
Consult the documentation
ISUALIZE
that
J5000 and
29