Inserting A Disk Drive - HP Visualize J5000 - Workstation Owner's Manual

Inserting a Disk Drive

To insert a drive, the procedure is virtually identical to the "removing"
steps above, except in the reverse order:
1. Carefully push the drive, which is already in its tray, straight into the
2. When the drive-tray's handle can engage the hooks on the left edge of
NOTE The drive tray will not go all the way into the slot if the handle has
already been folded flat against the front of the tray. Push the drive tray
into the slot firmly, and then push the handle flat against the front of the
tray.
Chapter 3
desired slot, making sure the drive-tray's handle is pulled away from
the front surface of the tray.
the slot, push the right end of the handle flush to the front of the
drive; this will seat the drive into its power and data connections.
When the handle gets flush to the front of the tray, it should engage
the retaining tab with a noticeable click.
Hot-Pluggable Hard Disk Drives
The Disk Drives
79