HP Visualize J5000 - Workstation Owner's Manual page 61

Figure 2-15 Removing the CD Drive Filler Panel
Filler panel must
be removed
before installing
the CD drive
4. Unpack the CD drive, avoiding shocks both mechanical and electrical.
CAUTION A drop of just a few inches onto a hard surface such as a desk or the floor
can generate large accelerations (hundreds of gees), which may damage
the device.
5. Install the CD drive into the bracket: the drive itself must be inserted
Chapter 2
Changing Your Computer's Hardware Configuration
That is, never let it drop onto the floor or even onto a desk; always set
it down gently. And take ESD (electrostatic discharge) precautions, so
static-electric sparks do not damage the electronic components.
into the CD drive bracket as shown below, and secured by four Torx
T-10 screws (two on each side) driven into the holes indicated by the
dashed lines. These screws ship with the filler.
CD Drive Installation
61