HP Visualize J5000 - Workstation Owner's Manual page 70

Changing Your Computer's Hardware Configuration
Floppy Drive Installation
Figure 2-23 Floppy Drive, Filler Installed into the DDS/Floppy Drive Bracket
6. Connect the power cable and the data (ribbon) cable to the floppy
drive.
7. Slide the bracket, now containing the floppy drive, into the floppy
drive bay. Observing—and manipulating, if necessary—from above,
make sure the drive's ribbon cable folds neatly and compactly, and its
ferrite bead (the elongated loop of iron-containing material) does not
hinder the folding process.
8. Seat the bracket into the main chassis, again taking care not to pinch
the cables as the floppy drive is being pushed into the bay. Insert the
two screws through the front of the tray to secure the assembly to the
main chassis.
9. Replace the floppy drive bay's EMI cover, and the computer's top
cover and front panel.
10. After rebooting, use SAM (the System Administration Manager) to
confirm that the sioflop and siofdc floppy drivers are in the kernel.
If they are not, use SAM to add them to the kernel (after adding
drivers to the kernel, rebooting is required in order to put them to
use.
For information on normal usage, see the chapter "Using Your 3.5-Inch
Floppy Disk Drive."
70 Chapter 2