Floppy Drive Installation - HP Visualize J5000 - Workstation Owner's Manual

Changing Your Computer's Hardware Configuration

Floppy Drive Installation

Floppy Drive Installation
To install a PC floppy drive into the J5000/J7000, follow the steps below:
1. Using standard static-suppression practices (described in the Preface
to this document), remove the computer's front panel, as described
earlier in "Removing the Front Panel" on page 44, and top cover, as
described in "Opening the Top Cover" on page 46. Then remove the
floppy-drive bay's EMI (electromagnetic interference) cover—the thin
metal cover that is snapped in place above the floppy drive bay.
2. Remove the two screws securing the DDS/floppy drive bracket to the
main chassis, and pull the bracket straight out. The bracket is
referred to as the "DDS/floppy drive bracket" because the same
bracket can house either a DDS drive or a floppy drive (but not both
simultaneously).
Figure 2-21 Removing the DDS/Floppy Drive Bracket
68 Chapter 2