5-Bin Mailbox Option Service Check - Lexmark C752 Service Manual

5060-2XX
Finisher
Step Actions and questions
1 Make sure the top options cable is correctly plugged
into the system board.
Is the cable correctly installed?
2 Make sure the finisher cable is correctly installed on
top of the printer.
Is the cable correctly installed?
3 Make sure the finisher cable is correcting install on the
finisher system board.
Is the cable correctly installed?
4 When 990 error is installed, press and hold Return and
Select to view the sub error code.
Scroll down with Menu to see the additional display
lines and view the value at the indicated position (EQC
and DB1) and match the information to the table below.
Finisher (Bin 1) - No other output options
26
DB1
DB5
Does the information on the table help find the
problem?
EQC DB1
45 05
4C 0C
50 10

5-bin mailbox option service check

Note: Before proceeding with this service check make sure the option(s) are installed correctly before
attempting to service the unit. Make sure the machine is configured correctly. The majority of the mechanical
components can be observed during operation by removing the left and right side covers.
Step Symptoms
1 Problems with excessive static electricity buildup.
2 The printer does not recognize one or more output
options as installed.
2-96
Service Manual
9D 81 EQC
DB2 DB3 DB4
DB6 DB7
Explanation
Jogger motor homing timeout error. Obstruction in Jogger, motor or sensor failure.
Offset motor timeout error. No clearance around output bin, motor or sensor failure.
Stapler unit is removed. Cable harness to stapler damaged or disconnected.
Yes No
Go to step 2 Install correctly
Go to step 3 Install correctly
Go to step 4 Install correctly
Repair the Contact your next
finisher as level of support.
indicated in the
table.
Yes No
Go to "Problems Go to step 2
with excessive
static electricity
buildup." on
page 2-126
Go to "The Go to step 3
printer does not
recognize one
or more output
options as
installed." on
page 2-98