Lexmark C752 Service Manual page 70

5060-2XX
User primary
message
54 Std Network
Software Error
54 Network x
Software Error
54 Serial Option x
Error
55 Unsupported
Option in Slot x
55 Unsupported
Flash in Slot x
56 Serial Port x
Disabled
56 Std Parallel Port
Disabled
56 Parallel Port x
Disabled
2-36
Service Manual
User secondary
Explanation
message
This message is displayed when the RIP software detects
that a network port is installed but cannot establish
communications with it.
Press Go to clear this message.
The printer disables all communications to the associated
network interface. No data may be received or sent from or
to the associated interface. The user can program new
firmware in the network using the parallel port after this
message clears.
This message is displayed when a serial error, either
framing, parity or overrun, is detected on the specified
(option x) serial port. This usually means the serial port is
not set up correctly.
Press Go to clear the message and continue processing the
print job.
Note: If the print job does not print correctly, make sure that
the correct cable is being used.
This message displays when an unsupported option is
installed or when an unsupported flash DIMM, such as a
C750 version, is installed in a memory slot.
Turn off the printer and remove the offending option.
These messages may appear when data is sent to the
printer across a serial port, but the port is disabled.
Note: Once the error is displayed the first time, reporting of
further errors is suppressed until the printer is reset or
menus are entered.
The following actions can be taken:
• Press Go to clear the message. Any data received on
• Press Menu to access the Busy/Waiting Menu.
The following functions may be available:
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
These messages may appear when data is sent to the
printer across a parallel port, but the port is disabled.
Note: Once the error is displayed the first time, reporting of
further errors is suppressed until the printer is reset or
menus are entered.
The following actions can be taken:
• Press Go to clear the message. Any data received on
• Press Menu to access the Busy/Waiting Menu.
The following functions may be available:
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
the serial port is discarded.
the parallel port is discarded.