Lexmark C752 Service Manual page 101

S2 or narrow media sensor made early
•
2D 0F—S2 sensor early
•
2D 02—S2 sensor early
•
2D 05—Narrow media sensor early
Note: See "Printer sensors" on page
Step Action and questions
1 Check tray for the edge guide setting and media
loading. Edge guides should be adjusted against edge
of media. Media should be fanned and lay flat in the
tray.
Is the media properly loaded in the tray?
2 Media may not have been cleared from a previous jam.
Is media in paper path?
S2 or narrow media sensor did not break in time
•
2D 04—S2 sensor did not break in time
•
2D 06—Narrow media sensor did not break in time
Note: See "Printer sensors" on page
Step Action and questions
1 Make sure the media installed in the tray meets
specifications.
Does the media meet specifications?
2 Check tray for the edge guide setting and media
loading. Edge guides should be adjusted against edge
of media. Media should be fanned and lay flat in the
tray.
Is the media properly loaded in the tray?
3 Remove the ITU and check for the jam at the second
transfer roll.
Is paper jammed at the second transfer roll?
5-3.
5-3.
Yes No
Go to step 2 Properly load
media.
Clear the paper Call your next
path. level of support
Yes No
Go to step 2 Inform the
customer that
media loaded in
Tray x does not
meet
specification
Go to step 3 Properly load
media.
Clear the jam. Call your next
level of support.
Diagnostic information
5060-2XX
2-67