Lexmark C752 Service Manual page 133

Ready bin x full message - may be able to clear message and will feed paper into bin
selected.
Note: This sensor is normally in a open position with the flag out of the sensor slot.
Step Action and questions
1 Bin x sensor (bin x=Sensor 1 through 5) - Make sure
the sensor is seated correctly in the side of tray x.
Is the sensor seated correctly?
2 Bin x sensor cable - Make sure that bin x sensor cable
is connected to the sensor and to the control board.
Is the sensor cable connected correctly?
3 Bin x sensor flag - Check the bin x sensor flag for
binding and proper operation.
Are there any problems with the sensor flag?
4 Bin x sensor cable - Check the continuity of the sensor
cable.
Is there continuity?
Bin x full - no message that bin x is full message
Step Action and questions
1 Bin x sensor (bin x=sensor 1 through 5) - Make sure
the sensor is seated correctly in the side of tray x.
Is the sensor seated correctly?
2 Bin x sensor cable - Make sure that bin x sensor cable
is connected to the sensor and to the control board.
Is the sensor cable connected correctly?
3 Bin x sensor flag - check the bin x sensor flag for
binding and proper operation.
Are there any problems with the sensor flag?
4 Bin x sensor cable - Check the continuity of the sensor
cable.
Is there continuity?
Ready - bin x full displays and paper feeds into bin x
Step Action and questions
1 Bin x sensor flag - Make sure the bin x sensor flag is
not in the up position and is operating correctly.
Is the sensor flag operating correctly?
Yes No
Go to step 2 Install the sensor
correctly
Go to step 3 Install the sensor
cable correctly
Repair or replace Go to step 4
the sensor flag
Replace the bin x Replace the bin x
sensor Cable
Yes No
Go to step 2 Install the sensor
correctly
Go to step 3 Install the sensor
cable correctly
Repair or replace Go to step 4
the sensor flag
Replace the bin x Replace the bin x
sensor cable
Yes No
Replace the bin x Repair or replace
sensor. If this as necessary
does not fix the
problem replace
the control board.
Diagnostic information
5060-2XX
2-99