4.
Remove connectors (D) from the right board.
5.
Remove developer HVPS boards.
6.
Reinstall HVPS boards.
Installation note:
1.
Disconnect the cable between boards.
2.
Install the large board by attaching the bottom screws loosely, attach the top screws, then tighten the
bottom screws.
3.
Connect the boards
4.
Install the small board in the same manner as the large board.
Friction buckler
1.
Press the multipurpose feeder (MPF) latch to disconnect the MPF.
2.
Use needlenose pliers to remove the buckler housing (A).
D
5060-2XX
4-31
Repair information