Lexmark C752 Service Manual page 66

5060-2XX
User primary
message
34 Short Paper
35 Res Save Off
Deficient Memory
36 Printer Service
Required
37 Insufficient
Collation Area
2-32
Service Manual
User secondary
Explanation
message
This message is displayed when the printer determines that
the paper length is too short to print the data as formatted.
The following actions can be taken:
• Press Go to clear the error and continue printing pages
• Press Menu to access the Busy/Waiting Menu.
The following functions are available using the Busy/Waiting
Menu:
• Cancel Job
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
This message displays when the printer lacks sufficient
memory to enable Resource Save. This message usually
indicates the user has allocated too much memory for one
or more of the printer link buffers; however, modification of
other printer settings which affect the amount of available
memory may also create this condition. If restoration of
Resource Save is required after this message is received,
the customer should install additional memory or set each
link buffer to Auto. Once all link buffers are returned to Auto,
you should exit the menus to activate the link buffer
changes. Once the printer returns to the Ready state, you
can then enable Resource Save and go back and modify the
link buffers, again. Note the reduction of available memory
to the link buffers when Resource Save has been enabled
and compare it to the memory available when Resource
Save is disabled.
This message is displayed when background toner prevents
a completion of a TPS calibration cycle. Service is required
to fix the problem.
Press Go to clear the error.
If the Service Printer message is displayed it means that a
TPS failure has most likely occurred. The printer continues
to operate but the color quality degrades. The most
probable cause for this error message is a defective print
cartridge or ITU.
This message is displayed when the printer memory and
disk used to store pages is too full to collate the print job.
The following actions can be taken:
• Press Go to clear the message and continue collating
• Press Menu to access the Busy/Waiting Menu.
The following functions are available using the Busy/Waiting
Menu:
• Cancel Job
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
or
the remaining pages of the job
or