Lexmark C752 Service Manual page 62

5060-2XX
User primary
message
Close Door
Close <tray> Door
Close Finisher Door
Disk Corrupted
Empty Hole Punch
Box
Priming Failed, Retry.
GO/Stop
Insert Staple
Cartridge
2-28
Service Manual
User secondary
Explanation
message
This message is displayed when the printer upper front
cover (door) is open.
Close the upper front cover (door).
This message is displayed when the HCIT (2000-sheet)
option tray door is open. Close the tray door to clear the
message.
This message is displayed when the Finisher Option front
door is open. Close the finisher front door.
This message is displayed when the printer has detected
that there are errors on the hard disk that could not be
corrected. The disk cannot be used until it has been
reformatted.
The following actions can be taken:
• Press Return or Stop to clear the message.
Warning: All data will be lost if you press Go to format the
disk.
This message is displayed when the Hole Punch Alarm is
On and the code has determined that the Hole Punch Waste
Box is completely full.
The following actions may be taken while this message is
displayed:
• The user may empty the Hole Punch Box and put it back
• Press Go to ignore the message and the job prints
Each time a new job requests Hole Punch and the box is not
emptied, this message is displayed.
This message is displayed when an error has occurred
during the printer staple priming operation.
The following actions can be taken:
• Press Go to initiate the priming operation again or
• Press Return or Stop to cancel the priming operation.
Note: If no action is taken and the printer Auto Continue
setting is not disabled, the printer eventually clears the
message, the priming operation is canceled, and the printer
resumes printing.
This message is displayed when the staple cartridge is
missing or installed incorrectly. This message can be
displayed at any of the following times, regardless of the
Staple Alarm setting.
• At POST
• After the Stapler Door has been closed.
The following actions can be taken:
• Install the staple cartridge
• Press Go to ignore this message.
The printer now handles staple jobs as if the staple unit
were installed with no staples. The Staples Empty warning
appears on the status line and Load Staples may
immediately appears.
The disk cannot be used without reformatting the disk.
to clear the message.
without hole punching.
or