20.
Position the mylar piece using two screws or one cable tie. When you place the mylar piece, make sure you
place it back under the metal bar (M) under the inner deflector. if a cable tie is used to secure the mylar
piece, make sure that the blue cable running under the mylar piece is retained by the cable tie.
BOR drive assembly
1.
Open the front cover.
2.
Remove the yellow toner cartridge.
3.
Remove the front right light shield cover.
4.
Remove the BOR housing assembly screw (A) type
and remove the assembly.
Note: Gear (B) can easily fall from the assembly. Be careful not to drop the gear.
M
"323" on page 4-3
5060-2XX
4-27
Repair information