S2/Narrow Media/Transparency/Multipurpose Feeder Cable - Lexmark C752 Service Manual

S2/narrow media/transparency/multipurpose feeder cable

1.
Remove the J21 connector cable to allow space. Note the route it shares with the sensor cable assembly
through the frame.
2.
Route the new cable connector through the rectangular opening in the upper frame and out through the
opening in the lower frame.
Note: Guiding the cable through the small opening requires patience. Use the following diagram as a guide.
Installation notes
•
When replacing the cable tie (A), make sure the tape on the cable protects the cable at the opening in the
frame (B) and is not pinched or obstructs the MPF door.
•
Make sure the cable at point C is clear of sharp edges.
5060-2XX
4-65
Repair information