Lexmark C752 Service Manual page 71

User primary User secondary
message message
56 Standard USB
Port Disabled
56 USB Port x
Disabled
57 Configuration Held Jobs May Not
Change Be Restored
Help Jobs May Not
be Restored
58 Too Many Trays
Attached
58 Too Many Bins
Attached
58 Too Many Disks
Installed
58 Too Many Flash
Options
Explanation
These messages may appear when data is sent to the
printer across the USB port, but the port is disabled.
Note: Once the error is displayed the first time, reporting of
further errors is suppressed until the printer is reset or
menus are entered.
The following actions can be taken:
• Press Go to clear the message. Any data received on
the USB port is discarded
• Press Menu to access the Busy/Waiting Menu.
The following functions may be available:
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
This message are displays when the printer has attempted
to Print and Hold jobs from the disk and found that some or
all of the jobs could not be restored. Each of the three
57 Configuration Held Jobs messages describe different
conditions under which the restore failed.
• Primary Message: 37 Insufficient Memory. The printer
firmware ran out of memory while attempting to restore
the jobs.
Secondary Message: Held Jobs May Not Be Restored.
• Primary Message: 57 Configuration Change - The
printer firmware could not restore jobs from the disk
because the configuration of the printer has changed.
Secondary Message: Held Jobs May Not Be Restored.
Some configuration changes that can cause a 57
Configuration Change message are:
- Code version change
- Paper handling option removed
- Disk drive has been moved to a different printer.
• Primary Message: Held Jobs May Not Be Restored
handles any other conditions where any of the Print and
Hold jobs could not be restored from the disk.
Note: Some of the Print and Hold jobs may not be restored.
They remain on the disk but cannot be accessed.
This message is displayed when too many trays are
attached to the printer. Check the specifications and verify
the number of trays allowed on each printer model.
This message is displayed when too many optional bins are
attached to the printer or if an unsupported combination of
bins is installed.
This message is displayed when too many disks are
installed.
Note: Some configurations of different output options
require the installation of one option before the other.
This message is displayed when too many Flash Options
are installed. Verify the maximum number of flash memory
options which may be installed.
Note: Press Go to clear the message. The extra flash
memory options are ignored.
5060-2XX
2-37
Diagnostic information