Configuring Vrrp Features (Cli); Configuring Vrrp Settings - Dell PowerConnect 7048P Manual

Configuring VRRP Features (CLI)

This section provides information about the commands you use to configure
VRRP settings on the switch. For more information about the commands, see
PowerConnect 7000 Series CLI Reference Guide
the

Configuring VRRP Settings

Beginning in Privileged EXEC mode, use the following commands to
configure switch and interface VRRP settings. This set of commands also
describes how to configure VRRP interface and route tracking.
Command
configure
ip vrrp
vlan-id
interface vlan
vr-id
vrrp
vr-id
vrrp description
vr-id
vrrp preempt [delay
seconds
]
vr-id
vrrp accept-mode
vr-id
vrrp priority
priority
vr-id ip-address
vrrp ip
[secondary]
1034
Configuring VRRP
Purpose
Enter global configuration mode.
Enable the administrative mode of VRRP for the router
(L3 switch).
Enter Interface Configuration mode for the specified
VLAN.
Allow the interface to create in the VRRP group specified
vr-id
by the parameter, which is a number from 1–255.
(Optional) Create a text description that identifies the
VRRP group.
Enable the preemption mode value for the virtual router
configured on a specified interface.
You can optionally configure a preempt delay, which is the
number of seconds the VRRP router waits before the
VRRP router sends an advertisement to claim master
ownership.
Allow the VRRP Master to accept ping packets sent to one
of the virtual router's IP addresses.
Set the priority value for the virtual router configured on
the interface.
Set the virtual router IP address value for an interface.
.