Ag-1008; Ag-1009; Ag-1010 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

Recommended Check the connectivity between the Access Gateway N_Port and the fabric switch port.
Action
Severity WARNING

AG-1008

Message
<timestamp>, [AG-1008], <sequence-number>,, WARNING, <system-name>, Invalid port
login (PLOGI) response from the fabric on the N_Port <port>.
Probable Cause Indicates the fabric switch management server did not accept the N_Port Login (PLOGI) request
sent by the Access Gateway.
Recommended Check the configuration of the fabric switch connected to the Access Gateway.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING

AG-1009

Message
<timestamp>, [AG-1009], <sequence-number>,, WARNING, <system-name>, Sending FLOGI
failed on N_Port <port>.
Probable Cause Indicates there was a failure sending a Fabric Login (FLOGI) request from the Access Gateway to
the fabric switch.
Recommended Please check the configuration of the fabric switch connected to the Access Gateway.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING

AG-1010

Message
<timestamp>, [AG-1010], <sequence-number>,, WARNING, <system-name>, Sending PLOGI
failed on N_Port <port>.
Probable Cause Indicates there was a failure sending an N_Port Login (PLOGI) request from the Access Gateway to
the fabric switch.
Recommended Check the configuration of the fabric switch connected to the Access Gateway.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
Fabric OS Message Reference
53-1001157-01
2
AG-1008
27