Swch-1004; Swch-1005; Swch-1006; Swch-1007 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

Brocade fabric os message reference guide v6.2.0 (53-1001157-01, april 2009)
Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:
Table of Contents

Advertisement

81

SWCH-1004

SWCH-1004
Message
<timestamp>, [SWCH-1004], <sequence-number>,, ERROR, <system-name>, Blade attach
failed during recovery, disabling slot =
Probable Cause
Indicates a blade has failed during failover or recovery.
Recommended
On a Brocade 24000 or 48000 switch, run the slotPowerOff command and then the slotPowerOn
Action
command.
On a Brocade 200E, 3250, 3850, 3900, 4012, 4016, 4018, 4020, 4024, 4100, 4900, 5000,
7500, or AP7600 switch, reboot or power cycle the switch
Severity
ERROR

SWCH-1005

Message
<timestamp>, [SWCH-1005], <sequence-number>,, ERROR, <system-name>, Diag attach
failed during recovery, disabling slot =
Probable Cause
Indicates the Diag blade attach has failed during failover or recovery.
Recommended
On a Brocade 24000 or 48000 switch, run the slotPowerOff command and then the slotPowerOn
Action
command.
On a Brocade 200E, 3250, 3850, 3900, 4012, 4016, 4018, 4020, 4024, 4100, 4900, 5000,
7500, or AP7600 switch, reboot or power cycle the switch.
Severity
ERROR

SWCH-1006

Message
<timestamp>, [SWCH-1006], <sequence-number>,, WARNING, <system-name>, HA state
out of sync: Standby CP (ver = <standby SWC version>) does not support NPIV
functionality. (active ver = <active SWC version>, NPIV devices = <'1' if NPIV
devices exist; Otherwise '0'. >).
Probable Cause
Indicates the standby control processor (CP) does not support N_Port ID Virtualization (NPIV)
functionality and the switch has some NPIV devices logged into the fabric.
Recommended
Load a firmware version on standby that supports NPIV functionality, using the firmwareDownload
Action
command.
Severity
WARNING

SWCH-1007

Message
<timestamp>, [SWCH-1007], <sequence-number>,, WARNING, <system-name>, Switch port
<port number> disabled due to \"<disable reason>\".
Probable Cause
Indicates the switch port is disabled due to the reason displayed in the message.
502
<slot number>.
<slot number>.
Fabric OS Message Reference
53-1001157-01

Advertisement

Table of Contents
loading

Table of Contents